If the SONET (OC-1) base data rate is 51.84 mbps, how much data can the Optical Carrier level 12 (OC-12) transfer in one second?
To access the Internet through the PSTN, what kind of connectivity device must you use?
Which of the following are characteristics of ATM?
Uses fixed-length cells of 53 bytes and adds labels to data units.
Which four of the following are the responsibility of the WAN service provider?
PSE, CO, DCE, Local Loop
Which network type divides transmitted data into smaller pieces and allows for multiple communications of the network medium?
Which of the following WAN technologies provides packet switching over high-quality digital lines at speeds greater than 1.544 Mbps?
Which WAN connection types use digital communications over public telephone lines?
ISDN and DSL
Which of the following is true of multiprotocol label switching?
It can carry ATM, SONET, and Ethernet traffic as well as CEF is required for all mpls-enabled cisco routers.
What is the maximum data rate of an ISDN BRI line?
Which of the following are characteristics of ISDN?
It provides enough bandwidth to transmit data at higher speeds than standard modems and analog lines, it lets you transmit voice, video, and data over the same lines, as well as it is a dialup service that uses existing copper wires for the local loop.
You have a series of WAN links that connects your site to multiple other sites. Each remote site is connected to your site using a dedicated link. What type of communication is being used?
Point to point
Which of the following devices is used on a WAN to convert synchronous serial signals into digital signal?
Which of the following WAN technologies provides digital dial-up connections on two 64 kbps data channels?
A healthcare organization provides mobile clinics throughout the world. Which technology should you select to transfer patient statistical data to a central database via the internet to ensure network connectivity for any clinic located anywhere in the world, even remote areas?
Which of the following is the most susceptible to interference related to atmospheric conditions?
Which of the following internet access technologies support simultaneous voice and data traffic over the same physical line?
ADSL and ISDN BRI
Which of the following internet services provides equal upload and download bandwidth?
Which of the following are characteristics of VDSL?
Supports both data and voice at the same time, and unequal download and upload speeds.
Which of the following technologies does GSM use to allow multiple connections on the same frequency?
Time division multiple access
Which of the following cellular network types does not provide internet connectivity?
Which of the following cellular network types use MIMO to increase 3g data throughput?
LTE and HSPA+
Which of the following describe the EDGE cellular technology?
Offers speeds of 400-1000 Kbps and the first internet compatible technology
Which of the following internet connection technologies requires that the location be within a limited distance of the telephone company central office?
Which of the following services are available regardless of whether the telephone company network is available?
Which type of internet service uses the DOCSIS specification?
Which of the following forms of networking are highly susceptible to eavesdropping and must be secured accordingly?
Which of the following are methods for providing centralized authentication, authorization, and accounting for remote access?
RADIUS and tacacs+
You have decided to implement a remote access solution that uses multiple remote access servers. You want to implement RADIUS to centralize remote access authentication and authorization.
Configure the remote access servers as RADIUS clients.
Which of the following protocols can be used to centralize remote access authentication?
You want to set up a service to allow multiple users to dial in to the office server from modems on their home computers. What service should you implement?
You are configuring your computer to dial up to the internet. What protocol should you use?
Which of the following protocols or services is commonly used on cable internet connections for user authentication?
You often travel away from the office. While traveling, you would like to use a modem on your laptop computer to connect directly to a server in your office and access files on that server you need.
You have just signed up for internet access using a local provider that gives you a fiber optic line into your house. From there, ethernet and wireless connections are used to create a small network within your home.
RADIUS is primarily used for what purpose?
Authenticating remote clients before access to the network is granted
Which of the following is a characteristic of TACACS+?
Encrypts the entire packet, not just authentication packets
Which of the following ports are used with TACACS?
Which type of device is required to implement port authentication through a switch?
Which of the following are characteristics of TACACS+?
Allows for a possible of three different servers, one each for authentication, authorizations, and accounting. It also uses TCP
You are troubleshooting physical layer issues with the Gi0/1 interface in a router. You need to view and analyze the number of collisions detected on the interface.
show interfaces gi0/1
You are troubleshooting physical layer issues with the Gi0/1 interface in a router. You suspect that a duplex mismatch error has occurred, and you need to determine the duplex settings configured on the interface.
show interfaces gi0/1 and show interfaces gi0/1 status
Review the output from the show interfaces fa0/1 command on the switch2 switch in the exhibit.
a duplex mismatch exists with the device on the other end of the connection
Consider the network shown in the exhibit. When you run the show interfaces command on switch1, you observe a significant number of runts on the gi0/1 interface.
Collisions are occurring.
You are reviewing the output of the show interfaces command for the gi0/1 interface on a switch. You notice a significant number of CRC errors displayed.
EMI or cross talk on the cable connected to the interface and collisions
You are reviewing the output of the show interfaces command for the gi0/1 interface on a switch. Which interference statistic displays the number of collisions that occurred after the 64th byte of the frame was transmitted?
A workstation is connected to a switch on the gi 0/2 interface using a straight through cable.
The switch attempts to sense the link speed. If it can’t, the slowest link speed supported on the interface is selected. If the link speed is 10 mbps or 100 mbps, half duplex is used. If the link speed is 100 mbps of faster, full duplex is used.
Consider the network shown in the exhibit. You have been experiencing intermittent connectivity issues with switch2. To check the status of the interfaces, you run the following commands:
The device connected to the fa0/1 interface has autonegotiation disabled.
Your organization recently opened a branch office in a remote area. Because of its location, traditional WAN connectivity was not available, so you contracted with a satellite provider to connect the branch office network to your home office network.
There is latency on the wan link
Your organization recently opened a branch office. You contracted with a wan service provider to connect the branch office network to your home office network. This morning, interface and protocol down
The wan interface on one or both routers has been disabled and there is a problem with the service provider’s network
Your organization recently opened a branch office. You contracted with a wan service provider to connect the branch office network to your home office network. This morning interface up and protocol down
There is a data link encapsulation protocol mismatch between the wan interfaces on both ends of the link
Your organization recently opened a branch office. You contracted with a wan service provider to connect the branch office network to your home office network. This morning interface up and protocol up
There is an ip address misconfiguration issue between the wan interfaces on both ends of the link